Publicité
Les langues disponibles
Les langues disponibles
Preparation
1.
Prepare a cross head screw driver.
2.
Read this instruction manual carefully before installation and use. Keep this
instruction manual and warranty card in a proper and safe place for future use
in case needed.
Installation:
1.
Put the main body up-side-down (Fig. A). Put the plug (#8) and power supply
cord through the holes on the center of Base Cover (#3) and Base (#2). Then
slide Base Cover (#3) , Base (#2) and Washer (#6) onto Main body respectively.
2.
Fix Washer (#6), Base (#2), Base Cover (#3) with Screw M6*20 (#1). Clip the
power supply cord with Cord Clip (#5) and fix it onto Base (#2) with Screw (#7).
Operations:
1.
Plug in the unit to a socket. Make sure the power supply is same as rated.
2.
Press Heater Switch to switch on or off the heater.
Cleaning:
Unplug the unit before cleaning. It should be wiped with wet cloth. Do not use too
much water.
Disposal of appliances and batteries
After the implementation of the European Directive 2002/96/EU in
the national legal system, the following applies:
Electrical and electronic devices may not be disposed of with
domestic waste. Consumers are obliged by law to return electrical
and electronic devices at the end of their service lives to the public
collecting points set up for this purpose or point of sale. Details to
this are defined by the national law of the respective country. This
symbol on the product, the instruction manual or the package
indicates that a product is subject to these regulations. By recycling,
reusing the materials or other forms of utilising old devices, you are
making an important contribution to protecting our environment.
13
EN
Publicité
