CTM LIBECCIO LX150F Mode D'emploi page 9

•
Before vacuuming liquids, check the float functions
correctly. When vacuuming liquids, and when the
tank is full, a float closes the suction opening, and the
vacuum operation is interrupted. Then switch off the
machine, disconnect the plug and empty the tank.
Regularly clean the water level limiting device (float)
and examine it for signs of damage.
• If the machine overturns, it would be recommended
to release the trigger gun and then stud up the ma-
chine.
• If foam or liquid escape from the appliance, switch off
immediately.
The equipment should not be used to pick up wa-
•
ter from containers lavatories, tubs, etc.
•
Aggressive solvents or detergents should not be used.
• Service and repairs must be carried out by qualified
personnel only. Only use manufacturer original spare
parts for service repair.
• The manufacturer cannot be held responsible for any
damage/injury caused to persons, animals or prop-
erty caused by misuse of the appliance, not in compli-
ance with manual instructions.
USAGE
(see fig. ⑧⑨⑩)
• Be sure that switch is in off position (0) OFF and con-
nect the machine to a suitable socket.
• The machine must be always kept on horizontal bas-
es, in a safe and stable way.
• Insert the suitable filters for the proper use.
•
Never use the appliance without filters .
• Use the most suitable accessories for the requested
usage.
• Put switch on (I) ON position in order to start the ma-
chine.
• When job is over, switch off (0) OFF and keep away the
plug from the socket.
• If the appliance is used with especially fine dust (size
below 0.3 µm) the filter supplied will require cleaning
more frequently. For especially demanding applica-
tions, the use of specific filters supplied as an optional
(Hepa) may be necessary.
CARE AND MAINTENANCE (see fig. ⑥⑦)
The unit is maintenance-free.
•
The machine shall be disconnected from its power
source, by removing the plug from the socket-outlet,
during cleaning or maintenance
• Clean the exterior part of the machine with a dry
cloth.
• Move the appliance only by catching the carrying
handle located on the motor head.
• Store the appliance and the accessories in a dry safe
place, out of the reach of children.
FILTER CLEANING R2
1- Remove the filter
2- wash tge filter
3- Let the filter drying befor reassemble it
•
Once the filter has been cleaned, check whether it is
suitable for further use. If it has been damaged or bro-
ken, replace it with an original filter.
WARRANTY CONDITIONS
All our machines are subjected to strict tests and are cov-
ered against manufacturing defects in accordance with
applicable regulations. The warranty is effective from
the date of purchase.
The following are not included in the warranty: - Parts
subject to normal wear. - Rubber parts, charcoal, filters
and the accessories and optional accessories. - Acciden-
tal damage, caused by transport, neglect or inadequate
treatment, incorrect or improper use and installation
failing - The warranty shall not cover any cleaning opera-
tions to which the operative components may be sub-
jected, such as clogged nozzles and filter blocked due
to limestones.
DISPOSAL (WEEE)
As the owner of electrical or electronic equip-
ment, the law (in accordance with the EU Direc-
tive 2012/19/EU on waste from electrical and electronic
equipment and the national laws of the EU Member
States that have implemented this Directive) prohibits
you from disposing of this product or its electrical / elec-
tronic accessories as municipal solid waste and obliges
you to make use of the appropriate waste collection
facilities.The product can be disposed of by returning
it to the distributor when a new product is purchased.
The new product must be equivalent to that being dis-
posed of. Disposing of the product in the environment
can cause great harm to the environment itself and hu-
man health.
The symbol in the figure indicates the urban waste
containers and it is strictly prohibited to dispose of the
equipment in these containers. Non-compliance with
the regulationtis spulated in the Directive 2012/19/EU
and the decrees implemented in the various EU Member
States is administratively punishable.
9