AQUA SPA T control 1H Guide D'utilisation Et D'entretien page 13

It is possible to connect a pump with a maximum power of 3HP. Maximum admissible load of
230V 2.7 KW.
Output protected with a safety fuse. If the fuse blows, a red led will light up in the FILTER button on
the front synoptic panel.
NOTE: For correct operation, if you wish to pilot the filtration pump using an external relay/remote
switch, eliminate condenser C4.
This operation must be carried out by qualified staff, at an assistance centre.
Massaging water jet pump connection
Connect the massaging water jet pump power supply cable to the OUT 2 clamp (N and F).
It is possible to connect a pump with an overall power of 2.0HP. Maximum admissible load of
230V 1.6 KW.
Output protected with a safety fuse. If the fuse blows, a red led will light up in the HYDRO button
on the front synoptic panel.
Level-control solenoid valve connection
Connect the solenoid valve power supply cable to the OUT 3 clamp (N and F).
Output protected with a safety fuse. If the fuse blows, a red led will light up in the level-control
solenoid valve indicator light on the front synoptic panel.
ATTENTION: the output voltage of the OUT3 clamp is 220Vac. To connect the solenoid valve at
24vac use the designated solenoid valve transformer kit TR324 code 100100835
CODE
F5
F6
F7
F8
F9
CAUTION!! Wiring and connection operations must be carried out by qualified staff. Only use
pumps with internal over-heating protection systems.
[OPERATION AND MAINTENANCE HANDBOOK
Description of protection fuses
FUNCTION
Lighting fuse
Filtration pump fuse
Massaging water jet pump fuse
Level-control solenoid valve fuse
Internal electronic fuse
]
[V-1.16]
FUSE VALUE
250 V - T 3.15 A
250 V - T 16 A
250 V - T 16 A
250 V - T 3.15 A
250 V - T 1 A
AQUA spa 13