Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
Can be used as a replacement remote control for 80
Series, 970 Series, and 370 Series LiftMaster remote
controls.
Compatible with 315 MHz or 390 MHz garage door
openers manufactured after January 1, 1993. Make
sure the garage door opener has a working light bulb
because it is a programming indicator.
For use with gate operators, commercial door
operators, or other products that are 315 MHz or 390
MHz and have a Learn button. Refer to your product
manual for the location of the Learn button.
PREPARE
PROGRAMMING THE REMOTE CONTROL
1
To enter programming mode, press the Program button
until the LED on the front of the remote control turns on.
893MAX
Visor Clip
895MAX
4
To exit programming mode, press
any remote control button except
the button that was just programmed.
MODEL 895MAX
MODEL 893MAX
MODEL 890MAX
Learn
OR
LED
Learn
LED
Green
or
Purple
Red/Orange
890MAX
Safety Pin or
Paper Clip
5
To test, press the programmed button on
the remote control...
MODELS 890MAX, 893MAX, AND 895MAX
LEDs
LED
LED
Locate the Learn
button on the garage
door opener.
NOTE: Your garage door
opener may look different.
OR
Learn
LED
Yellow
2
Press and release the
Learn button on the
garage door opener.
The Learn LED will light.
Within 30 seconds...
The garage door opener
will activate.
3-BUTTON REMOTE CONTROLS
To prevent possible SERIOUS INJURY or
DEATH from a moving gate or garage door:
• ALWAYS keep remote controls out of
reach of children. NEVER permit children
to operate or play with remote controls.
• Activate gate or door ONLY when it can be
seen clearly, is properly adjusted and there
are no obstructions to door travel.
• ALWAYS keep gate or garage door in sight
until completely closed. NEVER permit
anyone to cross path of moving gate or
door.
Locate the Program button on
the remote control.
Program Button
893MAX
3
Press and release the remote control button
you want to use...
Check to see if the garage
door opener light bulb
blinks.
If not, wait for the remote
control LED to light solid
then slowly press and
release the remote
control button again.
Repeat until the
light bulb blinks.
DO NOT press the
button after the light
bulb blinks.
6
Install the visor clip (not
applicable for Model 890MAX).
890MAX
895MAX
Publicité
Manuels Connexes pour LiftMaster 890MAX
Sommaire des Matières pour LiftMaster 890MAX
- Page 1 MODELS 890MAX, 893MAX, AND 895MAX Can be used as a replacement remote control for 80 MODEL 895MAX Series, 970 Series, and 370 Series LiftMaster remote controls. To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:...
- Page 2 REPLACEMENT PARTS ONE YEAR LIMITED WARRANTY 3V2032 Lithium Battery (Models 893MAX & 890MAX) ..10A20 The Chamberlain Group, Inc. warrants to the first consumer purchaser 3V2016 Lithium Battery (Model 895MAX) ....10A19 of this product that it is free from defect in materials and/or Visor Clip (Model 893MAX) .
- Page 3 TÉLÉCOMMANDES 3 BOUTONS MODÈLES 890MAX, 893MAX ET 895MAX Utilisation possible en tant que télécommande de MODÈLE 895MAX remplacement aux télécommandes LiftMaster AVERTISSEMENT séries 80, 970 et 370. Afin d’éliminer les risques de BLESSURES GRAVES ou Compatibles avec les ouvre-portes de garage 315 Voyants DEL de MORT découlant de l’actionnement d’une clôture ou...
- Page 4 GARANTIE LIMITÉE D’UN AN Pile au lithium 3 V 2032 (modèles 893MAX et 890MAX) ... 10A20 Pile au lithium 3 V 2016 (modèle 895MAX) ..... 10A19 La société...