Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GAS COMPONENT CONNECTION CHECKS
If the burner will not light or stay lit, please perform the following checks.
1. Make sure the electrode wire is correctly connected.
Both electrode wires must be fully inserted into the igniter box.
2. Make sure that the pilot housing is unobstructed.
Clear any debris on top of the pilot housing and make sure there is no debris
between the igniter pin, thermocouple and the burner tube.
CORRECT
Pilot Housing
Burner
Tube
Do not block
opening
INCORRECT
17
Publicité
Table des Matières
