Gas Component Checks - RealFlame Sedona C11813LP Manuel Du Propriétaire

GAS COMPONENT CONNECTION CHECKS
If the burner will not light or stay lit, please perform the following checks.
1. Make sure the electrode wire is correctly connected.
Both electrode wires must be fully inserted into the ignitor box.
2. Make sure that the igniter housing is unobstructed.
Clear any debris on top of the igniter housing and make sure there is
no debris between the igniter pin, thermocouple and the burner tube.
Igniter Housing
Burner
Tube
Do not block
opening
INCORRECT
CORRECT
16