Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
2. To drill the track section (F): Center and mark location on
the track section (F) where holes are to be drilled.
Drill a perpendicular 3/16 in. wide hole at mark.
Remove burrs and rough areas.
Do not damage insulators or conductors.
Mounting hardware (not included) should not come
in contact with insulators or conductors.
Note: A single section of track that is 4 ft or less in length
requires one mounting opening.
Mounting opening should be spaced a maximum of 6 in.
from the end of the track section (F).
Additional openings might also be provided.
3. Make electrical connections using wire connectors (BB).
Refer to ELECTRICAL CONNECTIONS in the Safety
Information section on page 3.
Install the mounting bracket (A) to the junction box
by using junction box screws (AA).
Hardware Used
Junction
AA
Box Screws
BB
Wire Connector
4. Determine location and attach track section (F) to
mounting bracket (A).
Secure with support screws (D).
Note location of electrical supply and place track section (F)
and supply connector (B) at desired location.
Mark the position on the ceiling with a light pencil mark,
using the holes in the track section (F) as a guide.
Remove track section (F) from the ceiling and place in an
easy to reach location.
5. To install fixture on drywall ceiling:
Use toggle bolts (CC).
Drill a 5/8 in. wide hole at each mark on ceiling.
Insert bolts through the holes in the track section (F).
Thread toggles 1/2 in. onto bolts.
Place track section (F) against ceiling.
Insert toggles into holes until the toggles spring open.
Tighten bolts.
Hardware Used
CC
Toggle Bolt
x 2
x 3
x 2
6
2
F
3
BB
A
AA
4
D
F
B
5
CC
Lowes.com/portfolio
A
F
Publicité
