If the appliance is connected to an underfloor system, install a limit thermostat to prevent the latter from overthing connec-
ted in series with a zone pump.
4. ACCESS TO PARAMETERS
To make settings, enter the parameters menu on the Remote Control as indicated below:
KEY TO FIGURE MENU
1
Enduser
2
Commissioning
The procedure for accessing the four menus in order to pro-
gramme the boiler board and/or the Remote Control is the fol-
lowing:
• from the main menu
•
A andC (hold down for approx. 6 seconds)
menu 1-2-3-4 (see figure to side and key).
•
C to go back one menu at a time to the main menu.
CONFIGURING THE RVS 46 ACCESSORY
CONFIGURING THE REMOTE CONTROL
• Access menu 2.
•
B
Commissioning
•
B
Operator unit
•
B
programme row 40
•
B
Room unit 1
CONFIGURING DEVICE ADDRESS
• Access menu 3.
•
B
Engineer
•
B
LPB system
•
B
programme row 6600
•
B
a value between 2 and 16
If the 16 addresses are full please select a new segment (2÷14) in order to have other 16 addresses free:
• Access menu 3.
•
B
Engineer
•
B
LPB system
•
B
programme row 6601
•
B
a value between 2 and 14
3
Engineer
4
OEM
C.
B to confirm.
B to confirm.
B to confirm.
B to confirm.
B to confirm.
B to confirm.
B to confirm.
B to confirm.
B to confirm.
B to confirm.
B to confirm.
B to confirm.
11
7105700.03 - 1-10/11