Batavus C1 Mode D'emploi page 4

Place the handlebar shaft onto the frame tube on
the base frame and fasten it using the screws and
the washers.
CAUTION:
Push the tube cover together with the housing
foam ring downward onto the housing.
HANDLEBAR
Assemble the handlebars using the handlebar
clamp, the screw, the washers, the spacer sleeve
and the hand wheel for adjusting the handlebars.
Place the handlebar tube into the holding fixture
(E) on the handlebar shaft.
(F) must be inserted into the groove (G)! Push
the handlebar clamp over the handlebar tube
and loosely insert the screw with the washer. The
handlebar clamp should wrap around the tube
uniformly. Insert the hand wheel for adjusting
the handlebars together with the washer and the
spacer sleeve into the upper hole and tighten. Push
the cable from the hand pulse sensors through the
opening (H) beneath the mounting plate (J) and
thread it upward out of the handlebar shaft.
CONSOLE
4
Do not pinch the cable!
: The pin
CAUTION
Insert the batteries on the back side of the console.
Connect the cable connectors coming out of
the handlebar shaft to the console and place the
console from above onto the mounting plate on
the handlebar shaft.
CAUTION
cable! Fasten the console using the screws. Do not
tighten the screws too much. Push the console cap
upward and latch it in the console bottom section.
Make sure that the latching pins (K) seat properly.
SEAT
Insert the seat support. Screw in the hand wheel
for adjusting the seat and latch the pin of the hand
wheel into a hole in the seat support. Tighten
the hand wheel. Fasten the seat to the triangular
mounting plate (L) of the seat support using the
nuts and the washers.
PEDALS
: Do not pinch the