Seac Sub Shot Instructions page 18

E E N N G G L L I I S S H H
• • Unscrew the lens ring nut anticlockwise.
• • Remove the battery holder.
• • Make sure to insert the batteries observing the correct polarity marks
(+ or -) shown on the holder.
• • Insert the battery holder into the body of the torch.
• • Lubricate the O-ring seal with a silicone grease film.
• • Screw the lens ring nut clockwise.
• • Switch on the torch to test.
W A A R R N N I I N N G G ! ! W
If the battery has not been installed properly (polarity inversion), a short
circuit will damage the equipment, with a serious risk of an explosion.
• • If the torch has not been recently used, check the state of the SHOT
torch batteries and switch on the torch to test.
• • Check for the p p e e r r f f e e c c t t s s e e a a l l o o f f t t h h e e b b o o d d y y .
• • When under water, check that there is n n o o c c o o n n t t i i n n u u o o u u s s d d i i s s c c h h a a r r g g e e o o f f a a i i r r
b b u u b b b b l l e e s s from the torch body.
18
B B A A T T T T E E R R Y Y R R E E P P L L A A C C E E M M E E N N T T : :
C C H H E E C C K K S S B B E E F F O O R R E E D D I I V V I I N N G G : :