Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Problem
Dirty water and
impurities come out of
the soleplate.
Water flushes out of the
soleplate.
The Calc-Clean process
does not start.
The iron leaves a shine
or an imprint on the
garment.
The ironing board cover
becomes wet, or there
are water droplets on
the floor/garment.
Possible cause
The Calc-Clean process has
not been completed.
Steam condenses into water
in the hose when you use
steam for the first time or
have not used it for a long
time.
Impurities or chemicals
present in the water have
deposited in the steam vents
and/or soleplate.
Steam condenses into water
in the hose when you use
steam for the first time or have
not used it for a long time.
You have accidentally started
the Calc-Clean process
(see chapter 'Cleaning and
maintenance').
You have not pressed the
CALC-CLEAN button for 2
seconds until the appliance
started beeping.
The surface to be ironed was
uneven, for instance because
you were ironing over a seam
or a fold in the garment.
There was not enough felt in
the ironing board cover.
Steam has condensed on the
ironing board cover after a
long ironing session.
You have an ironing board
that is not designed to cope
with the high steam rate of
the appliance.
Solution
You have to perform the Calc-Clean
process again (see chapter 'Cleaning and
maintenance').
This is normal. Hold the iron away from
the garment and press the steam trigger.
Wait until steam instead of water comes
out of the soleplate.
Perform the Calc-Clean process
regularly (see chapter 'Cleaning and
maintenance').
This is normal. Hold the iron away from
the garment and press the steam trigger.
Wait until steam instead of water comes
out of the soleplate.
Switch off the appliance. Then switch it
back on again. Let the iron heat up until
the 'iron ready' light lights up steadily.
See chapter 'Cleaning and maintenance'.
PerfectCare is safe on all garments. The
shine or imprint is not permanent and
will come off if you wash the garment.
Avoid ironing over seams or folds or you
can place a cotton cloth over the area to
be ironed to avoid imprints.
Put an extra layer of felt material under
the ironing board cover.
Replace the ironing board cover if the
foam or felt material has worn out.
You can also add an extra layer of felt
material under the ironing board cover
to prevent condensation on the ironing
board.
Put an extra layer of felt material under
the ironing board cover to prevent
condensation on the ironing board.
English
11
Publicité
Table des Matières
