Classic Accessories Ponderay Manuel De L'utilisateur page 11

P O N D E R A Y P O N T O O N B O A T O W N E R ' S M A N U A L
E. Attach the fly stripping apron by pressing rip-and-grip tape to the corresponding loop
tape on the pontoon.
F. There are two backrest support straps sewn to the seat backrest with a side release
buckle on either side. Be sure these buckles are clipped to their corresponding parts on
the inside pontoon. Adjust the length of the strap for a comfortable seat back angle.
G. T here are 3 sets of footrest rings located on the the pontoon. Simply clip each side to a
ring and adjust as needed for your leg position.
4. Assemble the oars
Your oars come in three sections. To assemble, slide the sections together, matching up
the spring loaded pins with the holes. To attach the oars to the boat, you will need to
disassemble the first third, insert into the oarlock and slide the section back into place.
5. The bladder repair kit
Included with your boat are self-adhesive tube patches to repair any tears or holes in the
pontoon bladders. We recommend storing these in one of the pockets to keep it available for
repairs.
6. Do the fitting and adjustments
Sit in the boat on dry land and adjust the footrest placement to your leg length and
preference.
Float your pontoon boat in shallow water. Push off, get seated comfortably, place your feet
on the footrests and check to see if you are level in the water. (This is easier with a another
person on shore letting you know if you are level or not).
WARNING - The goal is to find your balance point. When you are floating
in the boat it should be level in the water.
WARNING - If you need to adjust the footrests, bring the boat back to
shore and make the needed adjustments.
WARNING - DO NOT STAND UP IN YOUR BOAT WHILE ON THE WATER.
YOU COULD LOOSE YOUR BALANCE AND FALL OVERBOARD.
Practice going forward and backward a bit to get comfortable. Then catch some fish and enjoy
your boat!
11