Klarstein AZURIA Mode D'emploi page 43

EN
Drain excess water from the hoses.
If the sink is 1000 mm higher than the floor, the drain hose cannot be placed directly
into the sink. It is necessary to drain the excess water into a bowl or a suitable container
which is lower than the sink.
Water outlet
Connect the drain hose. The hose must be connected correctly to prevent leaks. Make
sure that the hose is not kinked.
Extension hose
If you need a hose extension, you should choose a hose that is similar to the drain
hose. The hose extension must not be longer than 4 metres, otherwise the dishwasher
performance may be impaired.
Connecting to the siphon
The discharge pipe must not be more than 100 cm higher than the underside of the
dishwasher. The water hose should be fixed.
Positioning the appliance
Place the device in the desired location. The back of the unit should be against a wall
and the sides of the dishwasher should be against the cabinet walls or walls. The
dishwasher is equipped with water inlet and outlet hoses that can be positioned either
on the left or right side of the appliance to simplify installation.
BEFORE FIRST USE
The following things should be checked before starting the dishwasher.
• The dishwasher is level and fixed properly.
• The inlet valve is open.
• The wires are tightly connected.
• The power is switched on.
• The inlet and drain hoses are knotted.
• All packing materials and printings should be taken out from the dishwasher.
43