Bosch GLI VariLED Professional Notice Originale page 15

OBJ_BUCH-1279-003.book Page 15 Tuesday, December 11, 2012 10:43 AM
 Do not continue to press the On/Off switch after the cordless worklight has
been automatically switched off. The battery can be damaged.
To remove the battery 4, press the battery unlocking button 5 and pull the battery to-
ward the rear out of the cordless worklight. Do not exert any force when doing this.
The battery is equipped with a NTC temperature control which allows charging only
within a temperature range of between 0 °C and 45 °C. A long battery service life is
achieved in this manner.
Observe the notes for disposal.
Operation
Initial Operation
Inserting the battery
 Use only original Bosch lithium ion batteries with the voltage listed on the
nameplate of your cordless worklight. Using other batteries can lead to injuries
and pose a fire hazard.
Insert the charged battery 4 into lamp head 3 until it can be felt to engage and faces
flush against the lamp head 3.
Switching On and Off
To start the cordless worklight, press the On/Off switch 2.
To switch off the cordless worklight, press the On/Off switch 2 again.
To save energy, only switch the cordless worklight on when using it.
Temperature Dependent Overload Protection
When exceeding the allowable heat-sink temperature of 60 °C, the cordless worklight
flashes 3x and then switches off. Allow the cordless worklight to cool down, then
switch the cordless worklight on again.
Working Advice
When the lighting duration is ≤ 10 minutes, the luminous efficiency of the cordless
worklight is lower.
The lens plate 1 is used to scatter or diffuse the light when using the cordless work-
light e.g., as a reading lamp.
Swivelling the Lamp Head (see figure A)
The lamp head 3 can be swivelled by 135° max. in 15° steps.
Bosch Power Tools
English | 15
1 609 92A 01W | (11.12.12)