Publicité
TOOLS
1 Safety
•
Read and follow all instructions of this manual carefully. Failure to follow the instructions and warnings can result in the
loss of the load, personal injury and property damage.
•
Do not overload the jacks stands beyond rated capacity. Overloading can cause damage to or failure of jack stands.
•
Position the load on the center of the saddle.
•
Always use the jack stands on hard, level surface. Use of stands on other than hard level surface can result in stand
instability and possible loss of the load.
•
No modifications should be made to the product. Accident hazard in case of improper use.
2 Specifications
Model
Capacity
Minimum/maximum height
Dimensions base
Dimensions rack
Net weight
3 Use
Saddle
Center
column
Pawl
Control lever
1. Refer the vehicle owner's manual for proper jacking procedure. Lift only on areas of the vehicle as specified by vehicle
manufacturer.
2. Position the stands under the vehicle at points specified by vehicle manufacturer as proper load support points.
3. To adjust stands height, hold the control lever up while lifting the saddle to desired height. Push the control lever down
to lock the pawl into the rack of the center column. Make sure the pawl is fully engaged into the teeth.
4. Carefully lower the load onto the stands.
4 Maintenance
•
Before each use, make a visual inspection of the stands. Check for missing or broken parts, cracked welds and any
other damage. A damaged stand should be removed from service immediately.
CAGS3T
3 t
288 / 425 mm
190 x 216 mm
267 x 100 mm
8.50 kg
before each use of the stands, checking for
before each use of the stands, checking for
missing and/or damaged parts. Any stand that
missing and/or damaged parts. Any stand that
way shal be removed from service immediatly.
way shal be removed from service immediatly.
HAZARDS ASSOCIATED WITH THE MISUSE
HAZARDS ASSOCIATED WITH THE MISUSE
NO MODIFICATIONS SHALL BE MADE TO THE
NO MODIFICATIONS SHALL BE MADE TO THE
gedaan voor elk gebruik van de
WIJZIGING MAG WORDEN UITGEVOERD
3
3
M1.1.CAGS3T-CAGS6T-CAGS12T.NLFREN 14062018
CAGS6T
CAGS12T
6 t
12 t
406 / 629 mm
468 / 715 mm
254 x 292 mm
305 x 317 mm
366 x 120 mm
467 x 162 mm
13.90 kg
30.00 kg
gedaan voor elk gebruik van de
,gescheurde lasnaden en ontbrekende
,gescheurde lasnaden en ontbrekende
Elke stand die op eender welke manier
Elke stand die op eender welke manier
uit dienst worden genomen.
uit dienst worden genomen.
VERBONDEN MET HET VERKEERDELIJK
VERBONDEN MET HET VERKEERDELIJK
WIJZIGING MAG WORDEN UITGEVOERD
être fait avant chaque utilisation des
être fait avant chaque utilisation des
déchirures, déchirures de soudage, des
déchirures, déchirures de soudage, des
manquantes. Chaque chandelle qui a
manquantes. Chaque chandelle qui a
.
4
.
EN
Publicité
