Important Safety Instructions - LiftMaster DKK Mode D'emploi

Important safety instructions

To prevent serious injuries resulting from loose parts
getting caught in the machinery, any cables or chains
connected to the door must be removed before you
install the door operator.
When installing and connecting the equipment, the
locally applicable building and electrical regulations
must be observed. Electricity cables may only be
connected to a properly earthed network.
Do not install this equipment in damp or wet rooms.
Only one person at a time should ever carry out
works to the door opener.
Live and moving parts of electrical machines can
cause serious or fatal injuries. Assembly, connection
and initial operation as well as servicing and repair
works may only be carried out by qualified specialist
personnel.
When working on the door opener, all local safety
guidelines must be observed. This device must be
installed in accordance with EN12453.
The operator may only be connected and operated in
accordance with the door standard EN: 13241-1 or
with the domestic standard EN 60335-1.
The technical data of the geared motor can be found on the identification plate or in
The following must be observed
- these instructions
- all further engineering documents relating to the door operator
- commissioning instructions and circuit diagrams
- the current national regulations (health and safety)
Warranty, storage
Compliance with the advice and instructions in this leaflet is the basis for trouble-free operation and for the acceptance of any warran-
ty claims. Please check the contents of the package immediately on delivery for any transport damage. Report any damage immediately
to the transport company and also to the supplier. If you do not intend to install the geared motor immediately, store it in a dry, dust-
free, low-vibration room at a temperature between –10°C and +60°C.
Condition on delivery
Every geared motor is manufactured in accordance with the technical documentation applicable at Chamberlain and is subjected to
a test run. The technical data and design are subject to alterations, in the interest of technical progress. The equipment is shipped in
appropriate packaging.
the accompanying documentation.
:
The three-button unit, the main disconnecting switch
and all other control equipment must be installed
within view of the door and out of reach of children.
Children should never be allowed to operate buttons
or remote control units. Misuse of the door opener
can lead to serious injuries.
The door opener may only be operated if the person
operating the equipment can see the entire door
area, the door area is free of obstructions, and the
door opener is properly adjusted. No one may walk
through the doorway when the door is in motion.
Children should never be allowed to play near the
door.
Before carrying out repair works or removing covers
from the door opener, install switch locks or discon-
nect the system from the power supply to ensure
that the operator cannot be set in motion unintenti-
onally.
All catches, fasteners and locks must be disabled
to prevent damage being caused to the door or the
door operator. Fix all catches, fasteners and locks in
the „open" position. If a fastener needs to remain
operational, a release switch must be installed.
3