Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2A) Timer after temperature regulation
Press "Timer" during cooking. The display shows "0:00".
-
With the keys "UP" and "DOWN" set the duration of cooking, up to 3 hours.
-
-
Display will show for some seconds the time set.
-
During cooking on the display will appear the temperature selected, and the time set.
-
Cooking will stop automatically when time finishes.
KEY LOCK
To lock the keypad on the control panel (4) press the key "Lock" during use. On display
the "Lock light" switches on to indicate the lock. To unlock press together the key "Lock" for 3 seconds.
SAFETY DEVICE
The unit turns off automatically if there is any pan placed on it, or it is removed, or it is made of such a
material not suitable for induction cooking.
In this case, the unit will show E0 for a while, and then goes into stand-by mode.
Every time you turn off the appliance by pressing the ON / OFF button, the fan will continue to run until
cooling down of any part of the unit. To turn off the product, always push the ON / OFF button, do not turn it
off by removing the cooking container or by unplugging the unit.
ERROR MESSAGE
Error
E0
Not suitable vessel.
Vessel is not placed inside
the cooking area. No vessel.
E1 / E2
Temperature sensor failure.
E3 / E4
High or low Voltage
E5
Crystal plate is overheating.
E6
Internal overheating
CLEANING -
Unplug the unit from the electrical power outlet and wait for the complete cooling
down of every parts before starting cleaning.
Do not immerse in water and never leave the appliance under the jet of tap water. In any case, prevent water
or other liquids to flow on the surfaces. Do not use abrasive or metal sponges for cleaning.
Clean the cooking plate with a damp sponge.
TECHNICAL FEATURES
•
Power supply: AC 230V
•
Temperature and power regulation
•
180 minutes timer - Key lock - Soft-touch buttons - Control lights
Cause
~
50/60Hz. Power 3100W (1800 + 1300)
Use only pans suitable with induction cooking.
Place the vessel on the cooking area.
Refer to Authorized Service since thermostat can be defective
Plug on a suitable electrical power outlet.
Let the plate cool down for and remove what is overheating
the glass. Restart operation only when the plate is cool.
Let the plate cool down and check the ventilation fan is not
obstructed, refer to an Authorized Service since the
thermostat could be defective.
Solution
14
Publicité
Table des Matières
