Do Height (Altitude) Compensation Value Setting; Escape From The Setting Function; Battery Replacement; System Reset - Tintometer Lovibond SensoDirect 150 Mode D'emploi

•
Use " " Up" , " " Down to select the desired % Salt Compensation Value.
•
Press "Enter" once, then press "ESC" to save the data and return to the normal
display.
•
% Salt is typically set to 0 %.

7.11 DO Height (Altitude) Compensation Value Setting

•
This procedure is only for the DO function.
•
The lower display will show:
0 = meter
1 = ft (foot)
•
Use " " Up, " " Down to select "0" or "1".
•
Press "Enter" once, and the lower display will show:
Height Value
Meter
•
Use " " Up, " " Down to select the desired Height value.
•
Press "Enter" once, then press "ESC" to save the data and return to the normal
display.
•
Typical setting is 0 meter (0 feet).

7.12 Escape from the SETTING function

Press "ESC" once to quit and return to the normal measurement display or press "Enter"!

8. Battery Replacement

1. When the left corner of the display shows "
teries (4x mignon size type AA 1.5V).
2. Unscrew the single retaining screw, and then slide open the "Battery Cover" (Fig.
A-10) and remove the batteries.
3. Replace with new batteries and slide on the cover. Replace the retaining screw.
4. Make sure the battery cover is tightly secured after changing the batteries.

9. System Reset

If the meter experiences problems, such as:
CPU system is garbled (for example, the key button cannot be operated.....).
Then system RESET will fix the problem. The system RESET procedure is as follows:
Use a pin tool to push the "System Reset Button" (Page 4, Fig. A-19). Then press "Power"
on again to fix the problem.
SensoDirect 150
FT= foot 1 Foot = 0.3048 m
", it is necessary to replace the bat-
37