Care And Cleaning - Cafe BELLISSIMO Manuel D'utilisation

Care and Cleaning

WARNING
Allow heating element to completely cool to avoid risk of fire or
injury and disconnect power prior to cleaning or service.
CAUTION
To avoid possible burns to body parts and/or other injury from
hot steam, do not touch liquids or steam wand during or after frothing. Do not
remove pitcher until steaming is complete. Hold milk pitcher by the handle.
Cleaning your Espresso Machine
■ Unplug the espresso machine from the wall.
■ Pour out all water left in the water tank and drip tray. Wash and air or towel dry.
■ Wipe down appliance using a non-scratch cloth and non-abrasive cleaner.
■ DO NOT place any part of the espresso machine in the dishwasher. Hand wash only.
NOTE: When not in use for long periods of time, such as vacation, run System Empty
Cycle, dry water tank, and open water tank lid.
Clean / Descale
Descale process consists of 2 stages and will take approximately 30 minutes. Clean
alert will turn off after both stages are completed.
DO NOT use any cleaning agents not provided with the product or recommended in this
manual.
NOTE: If descale is not properly completed, unit may timeout and return to IDLE state.
This will affect the quality of the coffee until all cleaning solution is removed as well as
the quality of descaling process. Run descale again.
NOTE: During descaling the unit will dispense continuously as well as pulse dispense for
a better cleaning.
STAGE 1:
1. Fill third of the water tank with water.
2. Add one pack of cleaning solution in the water tank (one tablet or packet). Mix well
until cleaning agent is fully dissolved.
3. Place a sufficiently large container under the brew head and steam wand.
4. Press and hold the Grind and Double buttons for 3 seconds to initiate. Clean alert
flashes.
5. Rotate the control knob to Steam. Water starts dispensing.
6. After Add Water LED turns on, rotate the control knob to the neutral position.
STAGE 2:
1. Remove, rinse , fully refill, and reinstall the water tank.
2. Repeat steps 3, 5, and 6 from STAGE 1.
3. Refill the water tank. Machine is ready for normal operation.
NOTE: As an alternative, a 1:1 ratio of water and white vinegar can be used as a cleaning
solution for the descaling process.
15