Muskoka MM251CH-1 Instructions D'assemblage page 3

gET REady To sTaRT
Before assembly, use scissors to unwrap the parts from the packaging. DO NOT use a box cutter or exacto-knife as
you may cut into the mantel pieces inside the box and damage the finish. Check for the hardware bag which is RED and
located inside the packaging, taped to the top box. Be sure you DO NOT discard any pieces.
M251CH
MANTEL
step 1
ART NAME
QTY.
1
BASE
Locate the base and place it on the floor. Do not put it up against
1
HT SIDE PANEL
the wall at this point in the assembly, as you need to get in behind
1
FT SIDE PANEL
the mantel to insert several wingnuts, lock washers and firebox screws.
1
HT FRONT PANEL
1
FT FRONT PANEL
1
CENTRAL HEADER
1
TOP
step 2
Locate the left side panel and the left front panel. Facing the front of the base, take
the left side panel, positioning it so the holes in the blocks on the bottom line up
with the holes on the base. Position the left front panel next to the left side panel,
lining up the holes in the blocks with the holes on the base. Attach the left front and
side panel to the base by inserting and tightening 1 wingnut and 1 lock washer to
each piece. Attach the left side and front panels together by inserting and tightening
2 wingnuts and 2 lock washers.
7
step 3
6
Repeat Step 2, but with the right side panel and the right front panel.
step 4 2
4
Locate the central header that will be attached to the left and right legs and will sit
above the firebox. Position this panel with the finished side facing the front of the
1
mantel. Line up the holes on each side and insert and tighten 1 wingnut and 1 lock
washer on each side.
step 5
Get your assistant and locate the top of your mantel. This top is very heavy. It will
take 2 people to lift and position it in place. Ensure the top goes over the positioning
guide located on the header. The top must go over this guide to be positioned
correctly. Line up the holes on the top of the mantel, insert and tighten 5 wing nuts
and lock washers.
DE PANEL
LEFT SIDE PANEL
7
3
6
5
1
RIGHT FRONT PANEL
TOP
2
4
LEFT FRONT PANEL
4PCS
2
BASE
CENTRAL HEADER
FLAT HEAD SCREW(4*16mm)4PCS
Step 1
Step 2 & 3
Step 4
Step 5