Publicité
Les langues disponibles
Les langues disponibles
NOTE: When the red indictor flickers, pull out the battery from the charger and insert again within
2 hours. If the indictor shows charging, that means the battery is good. After 2 hours, please pull
out the battery and also pull out the AC power plug of the charger for 1 minute, and then insert
the AC power plug and the battery again. If the indictor shows charging, that means the battery is
good. If not, the battery needs to be changed.
Checking the charger
If the battery pack does not charge properly:
• Check the current at the power outlet with another tool. Make sure that the outlet is not turned
off.
• Check that the charger contacts have not been shorted by debris or foreign material.
• If the surrounding air temperature is not normal room temperature, move the charger and
battery pack to a location where the temperature is between 7 ˚C and 40˚C .
This product requires assembly.
WARNING! If the battery is inserted into the charger when warm or hot, the CHARGING
LED indicator light on the charger may switch on and illuminate ORANGE. If this occurs allow
the battery to cool outside of the charger from approximately 30 minutes.
Charger mounting
1 - This charger can be installed hanging on a wall using two
screws (not supplied)
2 - Locate the placement for the charger to be wall mounted.
3 - If fastening to wood studs use 2 wood screws.
4 - Drill two holes 2 3/8" (6 cm) on center ensuring they are
level.
5 - If fastening to drywall use wall anchors and screws to
secure the charger to the wall.
NOTE: If the battery and the charger won't be used for a long
time, please remove the battery from the charger and pull out
the AC power plug.
BATTERY CHARGER
2 3/8" (6 cm)
89
EN
Publicité
