Maintenance And Storage - DESA Heating Products SPC-30RG Manuel Du Propriétaire

4. When the gas on the face of mesh screen
lights, continue to hold valve button
pressed for 30 seconds, then release.
5. If flame goes out, wait 5 minutes and
repeat lighting procedure.
6. If heater will not light after repeated tries,
do not attempt to repair heater. Return
heater to nearest authorized service cen-
ter or to manufacturer of this product.
7. For dual burner models, repeat steps 1
through 4 to ignite the other burner.
8. After both burners or single burner, are lit,
turn heater regulator knob to the desired
heat setting (LOW, MED, HI).
6 heat setting combinations:
Burner #1
LOW
MED
HI
LOW
MED
HI
1. Inspect heater before each use. Check
connections for leaks. Apply a noncor-
rosive leak detection fluid to connections.
Bubbles forming show a leak that must be
corrected. Correct all leaks at once. Have
heater inspected at least annually by a
qualified service person.
2. Before each use, check the soft "O" ring
seat at the bullnose of the POL fitting. If
"O" ring is cut, scuffed, or otherwise dam-
aged, replace it with part number 6681.
3. Inspect hose/regulator assembly before
each use. If hose is highly worn or cut,
replace.
6
OpeRaTIOn
Burner #2
OFF
OFF
OFF
LOW
MED
HI

MaInTenance and STORage

www.desatech.com
Continued
TO STOp HEATER
1. Securely close valve on propane/LP cyl-
inder.
2. Turn heater regulator knob to the OFF
position. Wait 15 minutes for heater to
cool down before handling heater.
3. Always remove heater from propane/LP
tank after each use. Do not store heater
while attached to propane/LP tank. Re-
move heater from propane/LP tank by
turning fuel connector nut clockwise.
Always store propane/LP tank outdoors.
Never store propane/LP tank in an en-
closed area.
TO RESTART HEATER
1. Securely close valve at propane/LP
cylinder.
2. Wait 5 minutes.
3. Restart following To Start Heater proce-
dure, page 5.
3. Turn off gas at propane/LP gas supply
cylinder when heater is not in use.
4. When heater is to be stored, connection
between propane/LP gas supply cylinder
and heater must be disconnected and
cylinder removed from heater and stored
out of doors and in accordance with
Chapter 5 of the standard for Storage and
Handling of Liquefied Petroleum Gases
ANSI/NFPA 58.
117240-01D