Assembly - DESA Heating Products SPC-30RG Manuel Du Propriétaire

14. If at any time gas odor is detected, IM-
MEDIATELY DISCONTINUE operation
until the source of gas has been located
and corrected.
15. Install the heater such that it is not directly
exposed to water spray, rain, dripping
water and/or wind.
16. Operate only on a stable, level surface.
17. Due to the high surface and exhaust
temperatures, adults and children must
observe clearances to avoid burns or
clothing ignition.
18. Do not move, handle or service while hot
or burning. Do not attach or remove a hot
or operating heater from the propane/LP
tank.
Estimated assembly time: 10 minutes
Tools required:
• Flat head screwdriver
• 7/8" wrench
Hardware packet provided with heater may
contain more parts than needed for heater
assembly. Hardware packet contains the fol-
lowing parts shown on page 8 (quantity used
in parenthesis):
Description
Burner Head Mounting Bracket (2) 114099-01
Screw (2)
Support Arm Bracket (1)
Wing Nut (2)
Screw, 5/6"-18 x 1.25 (2)
30,000 BTU MODELS ONLY
1. Inspect heater components for possible
shipping damage. If any is found, imme-
diately notify dealer. Check to make sure
that all components are included with your
heater (see pages 8 and 9).
2. Mount burner assembly onto support arm
using burner head mounting brackets and
screws as shown in Figure 1. Place side
of bracket into the slot on support arm.
Secure with screw. Make certain that the
air holes on the sides of the burner tube
are not blocked. Securely tighten the
burners into place.
3. Attach the electrode wires to the piezo
ignitor as shown in Figure 2.
4
SaFeTy
Continued
19. Before each use, check heater for leaks.
Never use an open flame to check for
leaks. Apply a mixture of liquid soap and
water to all joints. Bubbles forming show
a leak. Correct all leaks.
20. Keep all connections and fittings clean.
Make sure propane/LP tank valve is clean.
Check "O" ring on heater inlet fuel valve
connector for damage before each use.
Replace if worn or damaged.
21. Use only in accordance with local codes
or, in the absence of local codes, with the
Standard for the Storage and Handling of
Liquefied Petroleum Gases ANSI/NFPA
58 and CSA B149.1, Natural Gas and
Propane Installation Code.

aSSeMBly

part No.
114145-01
114096-01
115063-01 Screw
115062-01
Figure 2 - Attaching Electrode Wires to
www.desatech.com
Air Hole
Burner Head
Mounting Bracket
Figure 1 - Attaching Burner Head
Assembly to Support Arm
Piezo Ignitor
Electrode Wires
Piezo Ignitor
Burner Head
Assembly
Support
Slot
Arm
117240-01D