Needit POST IN Manuel D'utilisation page 27

USER MANUAL FOR POST IN WIRELESS MAIL
ANNOUNCING SYSTEM
Before using your new wireless mail announcing system, we recommend that you carefully read the
complete user manual.
POST IN wireless mail announcing system consists of
One receiver and one sensor.
Receiver figure A
1
2
HOW DOES POST IN WORK?
The sensor registers when mail is delivered to your mailbox and sends a signal to the receiver.
1
Button on the receiver flashes when receiving the signal. The button flashes for 0.05 seconds for
every 1.5 seconds. The flashing signal continues until the receiver is reset by pushing button
PRIOR TO FITTING
Activate the receiver and sensor.
The receiver and sensor are delivered with the batteries already in place. You activate them by
pulling out the clear foil in the direction of the arrows. The receiver and sensor are now ready for
synchronizing.
Synchronizing the receiver and sensor
1. Push and hold button
2. Activate the sensor by flipping it around its axis (shown as a stippled line, see figure B).
3. Synchronisation is complete when the button on the receiver is turned off. The unit is ready
for use after 10 seconds.
Please note: The transmitter must rest completely for 10 seconds between each activation.
3
1
on the receiver until the light is constant (about 5 seconds)
27
Sensor figure B
UK
1
.