LOADING (CONTINUED)
3. Pull the door open past 90 degrees. This will enable the door to stay
open for easy loading.
CLEANING
Regularly clean the inside and outside of your LidSaver.
1. Remove all lids from the LidSaver.
2. Push the sides of the bezel to release it from the plastic tabs. Pull the
bezel forward and tilt it downward allowing it to flex around the edge
of the open door.
2
4. Load lids with the front of the lid stack facing forward. Maximum
capacity is approximately 100 lids.
NOTICE: DO NOT overfill. Overfilling will compress lids which
may result in dispensing problems.
5. If dispensing tabbed lids, align all lid tabs either up (12:00) or
down (6:00) to avoid interference with the lid claws.
6. Gently close the door.
3. Remove the bezel.
4. Wipe the surfaces with a cotton cloth and warm soapy water.
5. Saturate each pager assembly with warm soapy water several times.
Flex the flipper portion of the pager to verify flippers operate freely.
Pager
Pager
6. Push the lid plate to the back of the tube to expose the bottom of
tube. Wipe the bottom of the tube.
7. Reverse steps 1-3 to re-install the bezel.
™
LidSaver
3 Lid Dispensers Operator's Manual
Pager
Lid Plate
Pager