Husqvarna K1 PACE Manuel D'utilisation page 6

the Bluetooth Low Energy (BLE) function. For more
information regarding how to use it, refer to
embedded connectivity with fleet on page 23 . For
information about the BLE technology radio spectrum,
Embedded connectivity on page 34 . For
refer to
compliance reservations regarding Husqvarna Fleet
™ Compliance reservations on page
Services , refer to
6 .
Compliance reservations
Note:
Changes or modifications made to this
equipment not expressly approved by Husqvarna may
void the equipment's compliance with FCC regulations,
and limit the user's authority to operate the equipment.
Note:
This device complies with Part 15 of the FCC
Rules and with Industry Canada licence-exempt RSS
standard(s).
Safety definitions
Warnings, cautions and notes are used to point out
specially important parts of the manual.
WARNING:
injury or death for the operator or bystanders
if the instructions in the manual are not
obeyed.
CAUTION:
damage to the product, other materials or
the adjacent area if the instructions in the
manual are not obeyed.
Note:
Used to give more information that is necessary
in a given situation.
General power tool safety warnings
WARNING:
and all instructions. Failure to follow the
warnings and instructions may result in
electric shock, fire and/or serious injury.
Note:
Save all warnings and instructions for future
reference. The term "power tool" in the warnings refers
to your mains-operated (corded) power tool or battery-
operated (cordless) power tool.
Work area safety
• Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
6
To use
Used if there is a risk of
Used if there is a risk of
Read all safety warnings
Operation is subject to the following two conditions:
• this device may not cause harmful interference
• this device must accept any interference received,
including interference that may cause undesired
operation
Product liability
As referred to in the product liability laws, we are not
liable for damages that our product causes if:
• the product is incorrectly repaired.
• the product is repaired with parts that are not
from the manufacturer or not approved by the
manufacturer.
• the product has an accessory that is not from the
manufacturer or not approved by the manufacturer.
• the product is not repaired at an approved service
center or by an approved authority.
Safety
• Do not operate power tools in explosive
atmospheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.
• Keep children and bystanders away while operating
a power tool. Distractions can cause you to lose
control.
Electrical safety
• Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power tools.
Unmodified plugs and matching outlets will reduce
risk of electric shock.
• Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
• Do not expose power tools to rain or wet conditions.
Water entering a power tool will increase the risk of
electric shock.
• Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool. Keep
cord away from heat, oil, sharp edges or moving
parts. Damaged or entangled cords increase the risk
of electric shock.
• When operating a power tool outdoors, use an
extension cord suitable for outdoor use. Use of a
cord suitable for outdoor use reduces the risk of
electric shock.
• If operating a power tool in a damp location is
unavoidable, use a residual circuit interrupter (RCD)
protected supply. Use of a RCD reduces the risk of
electric shock
1598 - 002 - 14.02.2022