Publicité
Les langues disponibles
Les langues disponibles
POSITIONING THE LIFTING FRAMES
The lifting frames can be positioned under the
vehicle in the following two ways: from the
outside in and from the inside out.
From the outside in
Park the vehicle in the desired location and
align the lifting frames between the wheels
along the vehicle's sides. If the distance
between the wheels is too short for there to
be room for the lifting frames, turn the lifting
frames and first push in one end and then the
other. Check that the Safety lock bars are facing
out. Move the lifting frames to the desired
positions under the vehicle. Avoid driving over
the hydraulic hoses.
From the inside out
1.
Put the lifting frames beside each other.
Check that the Safety lock bars are facing
out.
2.
Run forward the vehicle so that the lifting
frames are midway under the vehicle.
Avoid driving over the hydraulic hoses.
WARNING!
Do not drive the vehicle onto the lifting frames.
3.
Move the lifting frames to the desired
location at the vehicle's lifting points.
Positioning the lifting frames
under the vehicle
IMPORTANT:
•
Before positioning the lifting frames,
check that both lifting frames are fully
lowered and that the work area is free
from obstacles.
•
Check that the vehicle is well balanced
and cannot tip in any direction.
•
Never lift a load directly on the lifting
frames – always use lifting blocks.
1.
Determine the desired method for placing
the lifting frames under the vehicle.
2.
Place lifting blocks of the same thickness
on the lifting frames' plates.
3.
Place the lifting frames in a suitable place in
relation to the lifting points on the vehicle.
4.
Adjust the lifting blocks on the plates so
that they are directly beneath the vehicle's
lifting points.
5.
In this way, lifting frames and lifting blocks
are correctly positioned to lift the vehicle.
FIG. 9
FIG. 10
IMPORTANT:
The lifting frames must be in parallel under
the vehicle.
SAFETY LOCKBARS
On each lifting frame there is a lock bar that is
used to lock the frame in the required position.
Do not leave the product unattended if is not
fully lowerd or locked in on of the three locked
positions. Always check before use, that the
lock bar move easily and remain in their tracks.
The product will not work correctly if the lock
bar become stuck in their upper position or are
not located in their tracks.
LIFTING
1.
Press and hold the U button on the remote
control. The lifting frames are raised.
2.
Release the U button just before the
lifting block comes into contact with the
vehicle's lifting points. The lifting frames
stop moving. Check that the lifting blocks
are correctly aligned in relation to the
vehicle's lifting points. Adjust the lifting
blocks, if necessary. The vehicle may need
to be lowered slightly in order for the
lifting blocks to be able to be moved.
EN
39
Publicité
