Publicité
Les langues disponibles
Les langues disponibles
DECOR MODEL
INSTALLATION INSTRUCTIONS AND
OPERATING INSTRUCTION
READ AND SAVE THESE INSTRUCTIONS
1. GENERAL
1.1
Carefully read the following important information regarding in-
stallation safety and maintenance. Keep this information booklet ac-
cessible for further consultations. The appliance has been designed
external exhaust version cooker hood.
2. INSTALLATION INSTRUCTIONS
2.1
Power Supply Connection
For connection to the power supply refer to the follows:
BLACK
WHITE
GREEN / YELLOW = G ground
A double-pole switch properly rated must be installed to provide the
range hood power supply disconnection.
2.2 The appliance must be installed at a minimum height of 26
inches (66 cm) from an electric cooker stove, or 30 inches (76 cm)
from gas or combined cooker stoves. If a connection ductwork com-
posed of two parts is used, the upper part must be placed outside
the lower part. Do not connect the range hood exhaust duct air to the
same duct air used to exhaust hot air or fumes from other appliances
other than electrical.
2.3 Mounting the cooker hood to the wall. Drill holes A-B-C-D accord-
ing to indications quoted in (fig. 3).
Use screws and screw anchors suitable for wall (e.g. reinforced ce-
ment, plasterboard) for the mounting of the cooker hood.
Where screws and screw anchors are supplied ensure that they are
suitable for the type of wall where the cooker hood is to be mounted.
Lock in the flange connector Y to the cooker hood (fig. 2) with the
supplied screws.
Affix the bracket Z to the wall via the drill holes A (fig. 4) .
Hang the cooker hood on the wall using the drill holes C (fig. 3).
Fasten the cooker hood using the fastening drill holes D (fig. 3).
= L line
= N neutral
Publicité
