IARP GLOBO RETRO Instructions Pour L'utilisateur page 22

Modello - Modèle - Model
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
17. COVER ASSEMBLING
1. Screw in and fasten the supports (A) to the work surface.
2. Insert the two side sections (B) in the supports (A) and tighten the screws.
3. Insert and screw in the brackets (D) in the two side sections (B).
4. Insert the front section (C) in the Supports (A) and tighten the screws.
5. Screw in and fasten the front section (C) to the brackets (D).
A
1
B
B
A
4
18. MAINTENANCE
WARNING! Maintenance must be carried out by technical staff trained and enabled for intervention on the
flammable refrigerants.
WARNING! Any work carried out on the appliance by the user strictly requires the power plug being
disconnected from the mains socket.
ATTENTION! Use protective shoes and gloves during maintenance operations.
OPERATION
Cleaning of external surfaces
Cleaning of accessible internal parts (no use of tools)
Seals intactness check
Water collection tank cleaning
Checking and cleaning the condenser if necessary
Replacement components and parts
* Recommended frequency for optimal counter operation and maintenance of full efficiency.
Any other maintenance operation not planned in the previous points should be carried out by the
support centres authorised by our dealers or by qualified staff.
GLOBO RETRO'
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
B
A
2
D
B
5
FREQUENCY
Based on use
Based on use
B
C
MAINTENANCE
Ordinary
Ordinary
Yearly * Ordinary
Yearly * Ordinary
Yearly * Ordinary
- Extraordinary
2 2 / 6 4
PAGE
UM000550
N° DOC
D
B
3
D
AUTHORISED STAFF
User
User
Technical support
Technical support
Technical support
Technical support
B