Publicité
Les langues disponibles
Les langues disponibles
EXERCISE MONITOR INSTRUCTION MANUAL
SPECIFICATIONS:
TIME...........................................................................00:00-99:59
SPEED(SPD).....................................................0.0-99.9KM/H (ML/H)
DISTANCE(DIST)..................................................0.00-999.9KM (ML)
CALORIE(CAL).........................................................0.00-9999KCAL
※ODOMETER(ODO)..................................................0.0-9999KM (ML)
※PULSE (PUL) ............................................................................0，40~240BPM
KEY FUNCTIONS:
MODE(SELECT/RESET): This key lets you to select and lock on to a particular function you want.
OPERATION PROCEDURES:
1. AUTO ON/OFF
The system turns on when any key is pressed or when it sensor an input from the speed sensor.
The system turns off automatically when the speed has no signal input or no key are pressed for approximately 4 minutes.
2. RESET
The unit can be reset by either changing battery or pressing the MODE key for
3 seconds.
3. MODE
To choose the SCAN or LOCK if you do not want the scan mode, press the
MODE key when the pointer on the function you want which begins blinking.
FUNCTIONS:
1. TIME: Press the MODE key until pointer lock on to TIME. The total working time will be shown when starting exercise.
2. SPEED: Press the MODE key until the pointer advance to SPEED. The current speed will be shown.
3. DISTANCE: Press the MODE key until the pointer advance to DISTANCE. The distance of each workout will be displayed.
4. CALORIE: Press the MODE key until pointer lock on to CALORIE. The calorie burned will be displayed when starting
exercise.
5. ODOMETER (IF HAVE): Press the MODE key until the pointer advance to
ODEMETER. The total accumulated distance will be shown.
6. PULSE (IF HAVE): Press the MODE key until the pointer advance to PULSE .User's current heart rate will be displayed
in beats per minute. Place the palms of your hands on both of the contact pads(or put ear-clip to ear),and wait for 30
seconds for the most accurate reading.
SCAN: Automatically display changes every 4 seconds.
Note:
1.If the computer displays abnormally, please re-install the battery and try again.
2.Battery Spec: 1.5V AAA (2PCS).
3.The batteries must be removed from the appliance before it is scrapped and that they are
disposed of safety.
4.WARNING! Heart rate monitoring systems may be inaccurate. Over exercise may result in
serious injury or death. If you feel faint stop exercising immediately".
TROUBLE SHOOTING:
1.Change the battery. To change the computer battery, please slide the computer from the
computer holder, remove the battery cover on the back of the computer console, and remove the
batteries. Replace with AAA batteries. Finally put the cover back on the console, and slide the
computer back on the computer holder.
2.Computer not working correctly. If your computer is not working correctly, please check
whether the lower sensor wire is connected to the upper sensor wire, and make sure the upper
sensor wire is plugged into the computer. When you have checked the above, and the computer
still not working, then please make sure the batteries are installed correctly in the computer and
that the batteries are still working.
3.No resistance.
tension cable is connected to the lower tension cable.
E
X
E
R
C
I
E
X
E
R
C
I
If there is no tension resistance on the bike, please make sure the upper
S
E
C
O
M
P
U
T
E
R
S
E
C
O
M
P
U
T
E
N0:SMS_404
2021-2022
R
Publicité
