Publicité
Les langues disponibles
Les langues disponibles
Adjust the handlebar height
Loosen the locking screw of the stem with
1.
hex key 2.At this time, the height of the handle
bar can be adjusted by turning up and down
adjust it to a proper position, and then tighten
the locking screw.
Note: The pedals are not installed at the
factory and can be installed by using the
special wrench coming with the vehicle.
Remove the battery
1.Insert the key into lockhole by left hand, press it to the bottom, rotate it to the left in position, and keep still; 2.In
the meantime, grasp the handle of battery by right hand to pull the battery out.
Battery
Power indicator
capacity
button
light
Rotating
shaft
Note when installing the pedals: The pedal with "R"
symbol is the right pedal, and that with the "L"
symbol is the left pedal.
Press this button on the battery box to display the battery
capacity after the indicator light is lightened. More indicator lights
lightened shows more battery capacity.
This is the state after the battery is pulled
out. The battery can be taken out and
charged separately
EN-6
Upper and
lower
Locking
screw
Battery charging hole
Publicité
