Würth 0715 58 770 Traduction Des Instructions De Service D'origine page 9

You have just acquired an clamp multimeter and we thank you.
For best results from your device:
• read this user manual attentively,
• observe the precautions for its use.
Meanings of the symbols used on the device
Danger. The operator agrees to refer to this data sheet whenever this danger symbol is encountered.
Application or withdrawal authorized on uninsulated or bare conductors at dangerous voltages.
9 V battery.
The CE marking indicates compliance with European directives.
Double insulation or reinforced insulation.
Selective sorting of wastes for the recycling of electrical and electronic equipment within the European
Union.
In conformity with directive DEEE 2002/96/EC: this equipment must not be treated as household
waste.
AC – Alternating current.
AC and DC – Alternating and direct current.
Earth.
Risk of electric shock.
This device complies with safety standards IEC­61010­1 and 61010­2­032 for voltages of 1000V in category
III or 600 V in category IV at an altitude OF less than 2000m, indoors, with a degree of pollution not exceed-
ing 2.
These safety instructions are intended to ensure the safety of persons and proper operation of the device. If the
tester is used other than as specified in this data sheet, the protection provided by the device may be impaired.
• The operator and/or the responsible authority must carefully read and clearly understand the various pre-
cautions to be taken in use.
• If you use this instrument other than as specified, the protection it provides may be compromised, thereby
endangering you.
BDA_Vielfach-Messzange-Professional.indd 9
Start Guide
PRECAUTIONS FOR USE
9
21.12.16 15:29