Würth 0715 58 770 Traduction Des Instructions De Service D'origine page 12

1.1 THE SWITCH
The switch has six positions. To access the
desired function. Each setting is confirmed by an audible signal. The functions are described in the table below.
1.2 THE KEYS OF THE KEYPAD
12
BDA_Vielfach-Messzange-Professional.indd 12
, , , ,
Item Function
1 OFF mode – Switches the clamp multimeter off
2 AC, DC, AC+DC voltage measurement (V)
3 Continuity test
Resistance measurement Ω
Diode test
4 AC, DC, AC+DC current measurement (A)
5 Power measurements (W, var, VA) and
calculation of the power factor (PF) AC, DC,
AC+DC
Indicator of the order of the phases
6
Item Function
1 Storage of values, disabling of display
Zero correction A
Compensation of the resistance of the leads in
the continuity and ohmmeter function
2 Selection of the type of measurement (AC, DC,
AC+DC)
Selection of single-phase or three-phase
measurement
3 Activation or de-activation of the backlighting
of the display unit
4 Activation or de-activation of the MAX/MIN/
PEAK mode
Activation or de-activation of the INRUSH mode
in A
5 Measurements of frequency (Hz), of the level of
harmonics (THD)
Display of the powers W, VA, var and PF
6 Activation of the ΔREL mode – Display of
relative and differential values
, functions, set the switch to the
/A /W /W
DC AC+DC DC AC+DC
21.12.16 15:29