Maruyama E270 Manuel Du Propriétaire page 16

2. Move the choke lever to the closed (
And move the control lever to the high speed side
approximately half in. from the low speed side.
L:
Low speed
H:
High speed
Fast-idle lock button
WARNING
POTENTIAL HAZARD
• The components of your recoilstarter
assembly are under high spring tension.
If improperly disassembled these parts
maystrike you with considerable force,
possibly causing personal injury.
WHAT CAN HAPPEN
• Contact with the parts can cause severe
personal injury.
HOW TO AVOID THE HAZARD
• Never attempt to disassemble your
recoil starter assembly yourself.
A lways consult your authorized
MARUYAMA dealer for repair by quali-
fied service technicians.
CAUTION
• Do not pull the Starter rope all the way
out.
3. Grasp the throttle lever then push the fast-idle
lock button. Release your hand with holding the
fast-idle lock button to lock the fast-idle.
4. Pull the starter grip.
) position.
Throttle Trigger
Control Lever
Throttle Lever
5. After the engine starts, squeeze and release the
throttle trigger to return it to the idle position, then
move the choke lever to the open (
If the engine stops running before you move the
choke lever to the open (
Go ahead and open the choke, pull the starter grip
with the throttle trigger positioned at Fast-idle
position.
Hot Restart
To start an engine that is already warmed up (hot
restart), or if the ambient temperature exceeds 68°F
(20°C):
1. Pump the primer bulb at the bottom of the
carburetor until fuel can be seen flowing through
the fuel return line to the fuel tank.
(Flowing fuel should be almost clear, not foamy
or full of bubbles.)
2. Move the choke lever to the open (
3. Leave the throttle trigger in the idle position and
pull the starter grip.
4. If the engine fails to start after three to four pulls,
follow the instruction in the Cold Starting
Procedure section (US-14).
If the engine fails to start after you follow the
above procedu res, contact an author ized
MARUYAMA dealer.
To Stop The Engine:
1. Release the throttle lever.
2. Push the stop switch of the throttle trigger until
the engine will stop.
— US-15 —
) position:
Stop Switch
) position.
) position.