Presto H-DRY Notice D'installation page 13

5. Fix the stainless steel
cabinet to the wall, lead
the power cord through
the KO hole and connect
it to the dryer
7. Insert the wire set and
the grounding wire
through the flexible tube
9. Encase the packing onto
the wire set and the
grounding wire.
Reposition the packing
to the connector
11. Connect the grounding
wire
13. Install the dryer body
under the counter
POWER CORD
8. Remove the packing
air nozzle
10. Connect the wire set
12. Fasten two screws on
6. Connect the live wire to
the terminal block
marked "L". Connect the
neutral wire to the
terminal block marked
"N". Connect the ground
wire to the green screw
marked " "
from the connector.
Insert the wire set and
the grounding wire
through the air nozzle.
Fasten the flexible tube
to the air nozzle. Fasten
the other end of the
flexible tube to the shaft
of the spout
(including the sensor
wire and the LED wire) to
the CBM
the cover
packing
13