Installation Instructions - NewAir AB-1000 Manuel De L'utilisateur

INSTALLATION INSTRUCTIONS

● This appliance is designed to be free standing only, and should not be
recessed or built-in.
● Place your appliance on a floor that is strong enough to support the
appliance when it is fully loaded. To level your appliance, adjust the leveling
feet at the bottom of the appliance.
● Allow at least 4 inches (10 cm) of space between the top, the back and sides
of the appliance, which allows the proper air circulation to cool the
compressor and condenser.
● Locate the appliance away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat
sources may increase electrical consumption. Extreme cold ambient
temperatures may also cause the unit not to perfor m properly.
● Avoid locating the appliance in moist areas or where it could be in close
contact with water.
● Plug the unit into an exclusive, properly installed-grounded wall outlet. Do
not under any circumstances cut or remove the third (ground) prong from
the power cord. Any questions concerning power and/or grounding should
be directed toward a certified electrician or an authorized service center.
● After plugging the appliance into a wall outlet, allow the appliance to cool
down for 2-3 hours before placing any items in the compartment.
● To turn on internal LED lights, use the interior switch that is located inside
appliance on the right side of the device.
www.newair.com
EN
10