Wiring - Phase Linear PCD161A Manuel De L'utilisateur

PCD161A

WIRING

Antenna Connector
WARNING! Never combine (bridge) outputs
for use with 1 speaker.
WARNING! Never ground negative speaker
leads to chassis ground.
CAUTION: Failure to wire exactly as shown
may cause electrical damage to the radio.
LF/AVG
White/Black (-) Gray/Black (-)
White (+) Gray (+)
LR/ARG
Violet/Black (-)
Green/Black (-)
Green (+)
Violet (+)
5
Amplifier Wiring
Connect line out for optional
external amplifiers. The red
Gray
connector is for the right
and the white connector is
for the left.
Power Antenna
Connect to power antenna
or amplifier. If not used, tape
Blue
bare end of wire.
Ground
Black
Connect to ground terminal.
Yellow
Memory/Battery
+
15A Connect to battery or 12 volt
power source that is always
live. The radio will not work
if this wire is not connected.
Red
Accessory/Ignition
0.5A
Connect to existing radio
wire or radio fuse.
RF/AVD
Fuses
When replacing a fuse, make
sure the new fuse is the correct
type (AGC) and amperage.
RR/ARD
Using an incorrect fuse could
damage the radio.