T&S B-0600 Serie Instructions D'installation Et D'entretien page 4

General Instructions
Installation: B-0600
Other units will be similar, except where noted.
1. Shut off water supply and drain lines. Existing supply lines should be roughed
into wall or sink decking. Use ½" NPT inlets.
2. Install no.1 to supply line, using teflon tape. Flange of no.1 should screw in
toward body. Once no.1 is in place, adjust flange against wall or sink deck.
supply pipe
(supplied by others)
3. Attach no.11 to no.4 (with no.14 in place). Attach other end of no.11 to no.12
or no.13 (with no.14 and hold down ring in place, where used.)
4. Turn on water supply and check for leaks.
wall or sink
Note: Installation of B-0610 and B-0611
requires (2) two supply lines (Hot and
Cold) roughed into wall or sink deck, 8"
center to center. Use teflon tape on threads.
Note: B-0601, B-0606 and B-0611
do not have squeeze valves at end of
hose. No.13 is attached directly into
end of no.11.
flange