Maintenance; Storage - Worx Nitro WG572.X Serie Mode D'emploi

dispose of the pile.
Caution!
- Do not blow hard objects such as nails, bolts, or
rocks.
- Do not operate the blower near bystanders or
pets.
- Use extra care when cleaning debris from stairs
or other tight areas.
- Wear safety goggles or other suitable eye
protection, long pants, and shoes.
BATTERY STATUS (See Fig. F)
Light ON/ Flash
One Red on
Two LED-
lights off
One Red flash ----------
12
Two LED-
lights off
Three Green
on
---------- Charging
Three Green
flash

6. MAINTENANCE

CLEANING THE TOOL
Clean the tool regularly.
WARNING! Keep your product dry. Under no
circumstances spray with water.
- To clean the tool, use only mild soap and a damp
cloth.
- Do not use any type of detergent, cleaner or solvent
which may contain chemicals that could seriously
damage the plastic.
- Self lubricating bearings are used in your product,
therefore lubrication is not required.
Cordless Backpack Blower
Status
Defective Battery
NOTE: If a battery is
plugged in but no light
turns on, press the bat-
tery indicator button on
the basecamp. If a red
light is on at this time, the
battery is defective and
needs to replaced with a
new one.
Battery Temperature
Protection
The temperature of
battery pack is less than
32 F (0 C) or more than
0 0
113 F (45 C).
0 0
Fully Charged
NOTE: Press the battery
indicator button on the
basecamp, the light will
be three green on to
indicate a fully charging.
7. STORAGE (SEE FIG. L)
Stop the blower, and always remove the battery.
Clean the exterior of the machine thoroughly using
a soft brush and cloth. Do not use water, solvents
or polishes. Remove all grass and debris, especially
from the ventilation slots.
Store the machine in a dry place. Do not place other
objects on top of the machine.
FOR BATTERY TOOLS
The ambient temperature range for the use and
storage of tool and battery is 0 ℃-45 ℃ (32 ℉-113
℉).
The recommended ambient temperature range for
the charging system during charging is 0 ℃-40 ℃
(32 ℉-104 ℉).
EN