BUZZ D42 Notice D'utilisation page 20

9. Changing laser batteries
Turn off the laser and open the battery cover.
Change the batteries (CR 2032) and respect the polarity (the + in the direction of the battery cover).
10. Assembly of saw blade
Ziehen Sie vor dem Austausch des Sägeblatts den Netzstecker!
Change the saw blade only after disconnecting the power cable! Use only 125mm blades.
Refer to the diagram on page 34 to identify the elements.
a. Unplug the power cable
b. Set the cutting depth to the maximum position> 40 mm (depth stop).
c. Press the shaft locking device and insert the Allen key
GB
.
PAGE 38
d. Unscrew and remove the clamping screw and the locking washer by turning clockwise.
e. By pressing the switch on the safety cover, reassemble the base plate
upwards.
f. Position the saw blade and release the base plate.
WARNING!
The arrow on the saw blade must point in the same direction as the arrow indicated on the device.
Make sure that the speed of rotation of the saw blade matches that of the machine.
PAGE 39
GB