BUZZ D42 Notice D'utilisation page 16

GB
Read this operating manual thoroughly before using the plunge cut circular saw.
Wear protective goggles when working with the plunge cut circular saw.
Wear hearing protection when working with the plunge cut circular saw.
Wear a dust protection mask when working with the plunge cut circular saw.
Double isolation (Class II). There is no need for a grounded plug.
Risk warning: Risk of injury and risk of damage to the device.
Within the EU, this symbol indicates that this product should not be disposed of with the
domestic waste. Old devices contain valuable recyclable materials that should be recycled
and so as not to harm the environment or human health through uncontrolled waste dis-
posal. Please dispose of old devices therefore via suitable collection systems or send the
device for disposal to the point where you purchased it.
Made in PRC
PAGE 30
You have purchased a buzz saw from Broszio/Passat. We thank you for your trust in our product.
It is important that you read the operating manual carefully before putting the device into operation and observe
the safety instructions. Carefully retain this operating manual.
The manufacturer assumes no liability for damage and injuries resulting from improper use or disregard of the
safety instructions.
Important!
Please read all instructions because failure to follow these instructions could result in injury, electric
shock or fire.
Improper use of the device may cause personal injury or property damage. Only use the device for the purposes
stated in the operating manual. The manufacturer is not responsible for any damage caused by improper use or
handling of the device.
This device is not suitable for commercial use. Only suitable for 230V/50Hz. For more safety, the connection
can be earthed. Do not immerse the device, cables or plugs in water or other liquids. Use only in dry conditions.
Do not touch the device, plug or cable with wet or damp hands. Constantly monitor the device during use.
Children should not be left unattended to ensure that they do not play with the device. Do not cover the device.
The device must not be installed or operated near sources of heat, hot objects or naked flames. Make sure
people can not trip over the mains supply cable. Always switch the device off at the on/off switch. Pull out the
plug if not in use, on cleaning or when changing the bulb Never pull on the cable to pull out the plug. Pull only
on the plug. Do not wind the cable around the device. Use only extension cables that are approved for outdoor
use when working outdoors with power tools. You reduce the risk of electric shock as a result. Check regularly
whether cables or plugs are damaged. If this is the case, do not use the device and also not if it has been drop-
ped onto the ground or into the water or been damaged. If the mains supply cable is damaged, it must be repla-
ced by the manufacturer, their after-sales service or a person with the appropriate qualifications in order to avoid
risks. If you detect damage to the device or plug, the device must be disposed of or repaired by a specialist
workshop - risk of electric shock! Never try to repair the device yourself. Contact the dealer for repairs covered
by the warranty. Unauthorised repairs or modifications will void the warranty. Only connect the mains plug to
earthed sockets. Never change the plug. Never make any changes to the mains supply plug or mains supply
cable, this reducing the risk of electrical shock. Avoid contact with earthed surfaces, such as pipes, radiators,
cooker and refrigerators while the appliance is plugged into a socket. The risk of electric shock increases when
your body is connected to the earth.
This device must not be used by persons (including children) with limited physical, sensory or mental
capabilities or persons who are inexperienced or lacking knowledge, unless they are supervised by per-
sons responsible for their safety or have received instructions on how to use this device.
GB
PAGE 31