Power Brush (Sc12F70P Series) - Samsung SC12F70 Serie Manuel D'utilisation

POWER BRUSH (SC12F70P Series)

Checking the rotating floor brush and drive belt
You should check your vacuum cleaner's rotating floor brush and drive belt regularly for
wear or damage. You should also clean strings, hair, and carpet fibers off the brush and
brush ends. These can wrap around the brush and hamper its ability to effectively clean
your carpet. Also remove any debris that has accumulated under the brush cover.
1. Unplug the vacuum from the electrical outlet.
2. Place the handle in low position and turn the vacuum cleaner over so the bottom side is
up.
3. Remove the five screws (at arrows, right) with a screwdriver.
4. Remove the brush cover from the floor brush.
5. Grasp the rotating floor brush at both ends and lift.
6. Clean string, hair and other debris off the rotating floor brush, paying particular attention to
brush ends.
7. Clean string, hair and other debris off the motor pulley and drive belt areas.
8. Check the drive belt carefully for wear, cuts or stressed areas.
9. Check the air passageway for obstructions. Remove debris from this area.
The rotating floor brush could cause the fringe of a rug to become tangled within
CAUTION
the vacuum.
Use caution and turn off the floor brush when vacuuming throw rugs with fringe.
Maintenance _19