Otivio FlowOx 2.0 Guide Rapide page 2

Treatment - Regular use
2
1
1) Connect the Hose from the
Pressure Chamber to the Control
Unit.
2) Plug in external power supply to
the Control Unit before plugging it
into the wall socket.
7) After the treatment turn off the
device by pressing the on/off button.
E2 Major Air Leakage E3 Low Air Volume
Higher leakage than normal and Not enough air to function (Low air
treatment not being delivered volume)
Solution: Check the Seal, Hose Solution: check for obstruction, e.g.
with Filter and adjust if kinked hose.
necessary. Restart the device by Restart the device by pressing On/
Off Button.
pressing On/Off Button.
3) Gently pull the seal over
the outside of the Pressure
Chamber.
8) Roll down the seal onto
the outside of the Pressure
Chamber.
E4 Data transfer error
Data not transferred, e.g. due to taking
out USB Memory Stick too early or
software error
Solution: Switch off the device and try
inserting the USB Memory Stick into
the Control Unit again.
4) Place foot on top of 5) Pull the seal onto
positioner centrally in the leg to make the
Pressure Chamber. Pressure Chamber air
tight.
9) Remove the air 10)To remove air
from the padding by quickly press down on
pressing the release inner Padding.
valve button.
Time Card | When available time
on goes down to 25 hour or less,
hourglass and the time left will
show on display
Solution: Contact your clinician to
load more time with Time Card.
6) Start the treat-
ment by switching
on the device by
pressing the on/
off button.
Note:
If the problem persists,
contact clinician or local
distributor.
The Control Unit can be
reset by pressing On/Off
button for 13 seconds.
More information is avail-
able in the manual.
2