Berker 7541 40 04 Mode D'emploi page 11

GB
This device is a product of the instabus -KNX/EIB system and
complies with KNX directives.
Detailed technical knowledge obtained in instabus training courses
is a prerequisite to proper understanding.
The functionality of this device depends upon the software.
Detailed information on loadable software and attainable functionality
as well as the software itself can be obtained from the manufacturer's
product database.
Planning, installation and commissioning of the unit is effected by
means of KNX-certified software.
An updated version of the product database and the technical
descriptions are available in the Internet at www.berker.de
System information Safety instructions
Attention:
• Electrical equipment must be installed and fitted by qualified
electricians only and in strict observance of the relevant
accident prevention regulations.
• Failure to observe any of the installation instructions may
result in fire and other hazards.
• Risk of irreparable damage to the device!
U and GND must not be interconnected with the corres-
S
ponding terminals of another device.
Never supply sensors connected to the inputs of the analog
input (E1... E4) from the supply terminals U
connected analog input module.
GB
and GND of a
s