Zyxel PLA450 Serie Mode D'emploi page 3

1 Initial Hardware Connections
1
1 Screw the antenna clockwise onto the antenna connector. Make sure it is securely
attached. Point the antenna up (perpendicular to the ground).
2 Use the yellow (Ethernet) cable to connect the PLA450's LAN port to the Ethernet port
on your computer.
3 Use the included power cord to connect the POWER socket to an appropriate power
source. This is also your powerline connection.
1.1 Look at the LEDs (lights)
• Power ( ): Blinks until the device is ready.
• HomePlug (
• LAN ( ): Turns on if the LAN connection to your computer is OK.
• WLAN ( ): Turns on if the wireless LAN feature is on.
2
): Turns on when connected to other HomePlug AV device(s).
ENGLISH
3
3