Camera Installation - Conrad 856433 Mode D'emploi

When installing the parking aid system, bear in mind that torn-off pieces may pose a
risk of accident. Therefore, you should secure every component in a place where it
cannot be dangerous to passengers.
The camera must not obstruct the rear lights, the number plate, or any other part of
the vehicle's equipment, and it must not protrude from the vehicle.
These installation instructions do not apply to all vehicle types. Due to the great
number of car makes and models, the following installation steps should only be
taken as a general guideline. For questions concerning your vehicle, please consult
the manufacturer of your vehicle. Check the local regulations if use of the camera is
permissible.

7.1 Camera Installation

The following example shows the installation.
- Select an installation place for the camera.
- Check the path that the connection cable will take and decide where the power supply and monitor
connection will be placed.
- Look for a suitable cable feedthrough in your vehicle for the cable connecting the camera.
Some vehicles are already equipped with cable feedthroughs. If your car, lorry, or
motor caravan does not provide cable feedthroughs, appropriate holes must be dril-
led.
Before drilling holes in your vehicle, make sure that
• the vehicle electrical fittings will not be damaged
• the function of your vehicle is not negatively effected
• the operating licence does not lapse
• the fuel tank is not damaged
• your vehicle's safety or function is not impaired in any way.
If you are not sure whether the designated drill holes meet the criteria mentioned above,
consult a qualified automotive electrician. It is advisable to have a qualified automotive
electrician carry out the installation and the connection.
- Hold the camera mount against the designated mounting location.
- Mark the drill holes.
23