Publicité
Les langues disponibles
Les langues disponibles
JAUD1: Front Audio Connector
This connector allows you to connect audio jacks on the front panel.
JCI1: Chassis Intrusion Connector
This connector allows you to connect the chassis intrusion switch cable.
Using chassis intrusion detector
1.
Connect the JCI1 connector to the chassis intrusion switch/ sensor on the chassis.
2.
Close the chassis cover.
3.
Go to BIOS > SETTINGS > Security > Chassis Intrusion Configuration.
4.
Set Chassis Intrusion to Enabled.
5.
Press F10 to save and exit and then press the Enter key to select Yes.
6.
Once the chassis cover is opened again, a warning message will be displayed on
screen when the computer is turned on.
Resetting the chassis intrusion warning
1.
Go to BIOS > SETTINGS > Security > Chassis Intrusion Configuration.
2.
Set Chassis Intrusion to Reset.
3.
Press F10 to save and exit and then press the Enter key to select Yes.
1
MIC L
3
MIC R
5
Head Phone R
7
SENSE_SEND
9
Head Phone L
Normal
(default)
2
10
1
9
2
Ground
4
NC
6
MIC Detection
8
No Pin
10
Head Phone Detection
Trigger the chassis
intrusion event
Overview of Components
21
Publicité
