Oster 3157 Manuel D'instructions page 5

INSTRUCTIONS FOR USE
BEFORE USING YOUR JUICE EXTRACTOR
Follow the assembling instructions listed below before using your Oster® Juice
Extractor:
Figure 1
Figure 2
Figure 3
• Before you start assembling your juice extractor, make
sure it is unplugged and it is placed on a dry and
level surface
• Place filter basket on top of the motor base (Figure 1)
• Place the stainless steel filter on top of the filter basket
pushing down and turning it until it fits into the grooves of
the motor shaft (Figure 2)
• Place juicer cover/lid on top of the filter basket (Figure 3)
• Raise the safety locking arms, then lower them to
securely fit into the grooves in the lid and then firmly
press lower part of the locking arms into the unit ensuring
they lock the lid into the unit (Figure 4)
• Place the pulp container into position by tilting it slightly
(Figure 5)
Important: Make sure Pulp Container edge is
underneath basket
• Place the 600 mL jar under the spout located on the right
hand side of the juicer by tilting it slightly. Other jars or
glasses can be used as well (Figure 6)
Figure 5
Figure 4
4
Figure 6