EUFAB 21025 Directives De Montage page 9

Art.-No. 21025
Motorcycle hoist
Assembly instructions
Before putting the hoist into use, read all of the safety regulations and operating notes detailed in this set of instructions
carefully and apply them at all costs!
Technical data:
Maximum load:
Minimum lift:
Maximum lift:
Net weight:
Safety instructions
Before using the vehicle hoist, read all notes regarding operation and make sure you have understood them. All notes and
regulations must be observed at all costs. Only use the hoist on a firm, even surface. The specified load-carrying capacity may
NOT be exceeded. The unit is only designed to lift loads. Once the load has been lifted, it must immediately be secured using
suitable means. Ignoring the operating specifications may lead to injuries and/or damage to property.
To prevent serious injuries, never work on, under or in the vicinity of a load!
Safety at work
1. This hoist is designed with a maximum load-carrying capacity of 680 kg. This specified load may NOT be exceeded. Putting
a greater load on the vehicle hoist may lead to malfunctions or damages.
2. The load must ALWAYS be secured to the hoist using lashing straps.
3. ONLY operate the vehicle hoist on a firm, even and sufficiently stable surface.
4. BEFORE the load can be moved to another position, it must ALWAYS be moved to the lowest possible position on the hoist.
5. When a load has been lifted, ALWAYS apply the safety mechanisms in order to prevent unintentional lowering of the load.
6. ALWAYS inspect the vehicle hoist before use.
7. Do NOT use the unit if you can see that liquid has leaked and/or there are broken, twisted, torn parts or parts damaged in
any other way.
8. ALWAYS wear protective goggles when using the vehicle hoist.
9. Ignoring the notes contained in this set of instructions can lead to injuries and damage to property.
Assembly
Positioning the parts: See Figure 1
1. Attach the hydraulic cylinder (I) with the screw M6 x 15 (7) to the connecting rod (E). Then fix the cylinder using two M8 x 25
hexagonal screws (5), two spring washers (1) and 2 washers (6) to the base frame (A). Tighten all the connecting elements.
2. Insert the foot-operated lever rod (J) into the appropriate receptacle on the hydraulic cylinder (I) and use the M8 x 12
hexagonal screw (4) to fix it in place.
3. Attach the safety gate (D) to the safety mechanism (N) using 2 spring washers Ø 8 (1) and 2 M8 nuts (2).
4. Using the split-pin (3), fix the handle (F) to the connecting rod (E).
5. Check to make sure all connections are tight, and if necessary tighten them.
Components
Part Description
A Base frame
B Connecting piece
C Contact surface
D Safety gate
E Connecting rod
F Handle
G Adjustment screws
H Retaining spring
I Hydraulic cylinder
J Foot lever module
K Release lever
L Pump spring
M Lockable transportable rollers, rear
module
N Safety mechanism
O Transportation rollers, front module
P Eyes for holding straps
Q Clamp
R Safety locking spring
680 kg
130 kg
430 kg
34 kg
Quantity
1
1
1
1
1
1
2
1
1
1
1
1
2
2
2
4
1
1
Small parts
Part Description
1 Spring washer Ø i
2 Nut, M8
3 Split-pin
4 Screw M8 x 12
5 Screw M8 x 25
6 Washer Ø 8
7 Screw M6 x 15
Lashing straps 25 x 4570 mm
8
Quantity
4
2
1
1
2
2
1
2