Publicité
Les langues disponibles
Les langues disponibles
COMPONENTS OF
THE DEVICE [ insert_p 1]
1 Hot air vent
2 Anti-bacterial filter
3 Water reservoir
4 Cool air vent
5 Handle
6 Touch control buttons
7 LED atmospheric light
8 Reservoir cap
9 USB port
10 USB cable
11 Cooler tank drain plug
INSTRUCTIONS FOR USE
The refreshing effect of the Breezy Cube
increases as the relative humidity falls. The
drier the surrounding air, the more you will
feel the cooling effect. The personal space
cooler is most effective when it is used in
warm, slightly humid weather when hu-
midity does not exceed 60%.
Moving the device
Make sure you always move the Breezy
Cube using the handle, according to
Instructions prior to using
the device for the first time
Remove the air cooler from its original
packaging and check that it does not have
any faults. If you notice any faults, return it
to the supplier or the supplier's after-sales
department.
report_p Remove the air vent and
the piece of foam on the top
of the filter: this was used
to transport the device so
you can dispose of it.
Place the Breezy Cube personal air cooler
in the room half an hour before turning it
on to allow it to adjust to room temperature.
Filling the reservoir [ insert_p 3]
report_p Please note:
Before filling the device
with water, disconnect the
power adapter from the wall
socket and from the device.
Use only clean distilled or
demineralised water in order
to avoid any malfunction.
Make sure the reservoir
cap is tightly closed after
filling in order to avoid any
leakage or electric shocks.
The reservoir must be kept
clean. Please refer to the
chapter on "Maintenance
and storage" below.
E-IM-BreezyCube-003-Version 2-3colonnes.indd 7
E-IM-BreezyCube-003-Version 2-3colonnes.indd 7
•
Remove the reservoir by lifting it
and keep it upside down
•
Turn the reservoir cap in an anti-clock-
wise direction to open it
•
Then pour clean, fresh, distilled or dem-
ineralised water into the reservoir
•
Replace the cap and turn in a clockwise
direction to close it tightly.
•
Before placing the reservoir on the base
of the device, make sure you close the
cooler tank drain plug tightly
to avoid any leakage or electric shocks.
•
Finally, fit the reservoir correctly on to
the base of the device.
Instructions for use [ insert_p 4]
report_p Do not move the air cooler
when it is being used or when
water is left in the reservoir.
In fact, a system for draining
water that has accumulated is
provided to ensure your safety
and this might cause leakages
when moving the device if
it still has water in it. Always
therefore empty the reservoir
.
before moving the device.
[ insert_p 2]
report_p Make sure your hands are
completely dry when connecting
and disconnecting the device.
The Breezy Cube personal air cooler comes
with a USB cable and an adaptor of 2.0A. Once
the air cooler is turned on, it is ready for use.
•
Adjust the slots of the air vent upwards
or downwards to direct the air flow as
required.
•
Press the ON/OFF button
LED light indicates that the ventilation
and the atmospheric light are working.
•
Press it a second time: the atmospheric
light is disabled.
info_out Turning the mood light off
enters the unit in night mode. It
then automatically switches to the
lowest intensity to be quieter. To
exit the night mode and return
to the previous settings, press
the intensity or timer button.
•
The cooler runs continuously by default.
Press the timer button
the run time for 2 hours and a second
time to set a 4-hour run time. A blue
LED light indicates the length of time
selected.
•
Press the intensity control button
to go from the lowest intensity to the
highest intensity and vice versa. A blue
LED light indicates the intensity selected.
•
When the reservoir is empty, a red lu-
minous light appears on the ON/OFF
button
.
[ label 1]
info_out The device can continue to be
[ label 1]
.
used when the reservoir is empty
[ label 2]
in order to benefit from the fan.
.
It is even recommended that the
[ label 3]
fan be allowed to turn with the
.
reservoir empty from time to time
[ label 4]
in order to dry the filter completely.
•
If this same light flashes, the filter must
be replaced (approximately every 6
months). Please refer to the chapter on
.
[ insert_p 1 label 11]
"replacing the filter" below.
•
Press the ON/OFF button once again:
the air cooler switches off.
report_p DO NOT LEAVE THE
DEVICE CONNECTED WHEN
YOU ARE NOT USING IT.
MAINTENANCE
AND STORAGE
•
Always switch off the air cooler before
cleaning it or storing it.
•
If the water contains too much calcium
and magnesium, it may deposit a "white
powder" in the device. If too much foam
is deposited on the device, this will pre-
vent it from working properly.
Maintenance
We recommend:
1 Using clean distilled or demineralised
water each time the device is used.
2 Cleaning the reservoir every 2 days.
3 Cleaning the device (see expla-
nations below) and making sure
that all of its parts are completely
dry when it is not in use.
: a blue
[ label 1]
To clean the reservoir:
1 Clean the water reservoir with
water using a soft cloth and
vinegar if there are any foam or
limescale deposits on the inside.
2 Rinse the reservoir in clean water.
To clean the filter:
1 Remove the filter by referring to
2 Clean by brushing with a soft
brush (not supplied).
To clean the surface of the cooler:
once to set
[ label 2]
1 Clean the surface of the device
with a clean, soft, slightly damp
cloth as often as necessary.
2 Never use detergents, an excessive
volume of water, treated cloths,
[ label 3]
cleaning agents or abrasive sprays.
Storage
If you do not intend to use the device for a
lengthy period, remove the filter and allow
it to dry completely
it in a protective package and store it with
the clean, dry device in a cool, dry place
away from the light.
.
[ insert_p 5]
, then wrap
[ insert_p 5 label 1-3]
7
/ 56 English
11-03-21 14:23:35
11-03-21 14:23:35
Publicité
